1. Preliminary preparation

Prior to installing solar panels, we need to do a progression of starter arrangements. In the first place, it is important to evaluate the heap bearing limit and underlying dependability of the rooftop to guarantee that the rooftop can endure the heaviness of the solar panels and the heap that might be created during establishment. Also, it is important to check whether the waterproof layer of the rooftop is unblemished to abstain from harming the waterproof layer during the establishment cycle and causing water spillage. Moreover, it is additionally important to comprehend the nearby solar radiation circumstance and strategy guidelines to decide the best area and limit with regards to installing solar panels.

2. Install the bracket

The support is an important part of supporting solar panels, and its installation quality directly affects the stability and power generation efficiency of the panels. When installing the bracket, the installation position and Angle of the bracket must first be determined according to the actual situation of the roof to ensure that the panel can receive solar radiation to the maximum extent. Then, assemble and fix the support according to the installation instructions to ensure the stability and level of the support.

3. Install solar panels

After the installation of the bracket is complete, the installation of the solar panels can begin. First of all, the electric board is placed on the bracket in a predetermined order, paying attention to keeping the spacing and Angle between the electric board consistent. The panels are then connected in series and parallel using special connectors and cables to form solar cells. During the connection process, ensure that the connector of the cable is firm and well insulated to avoid problems such as leakage and short circuit.

4. System debugging and acceptance

After the installation is completed, the entire solar panel power generation system needs to be debugging and acceptance. First of all, check whether all the connection parts are firm, whether the cable is intact, and whether the electrical board is damaged. Then, turn on the inverter for trial operation to observe whether the system is running normally and whether the power generation reaches the expected level. In the debugging process, if any problem is found, it should be handled and recorded in time to ensure that the system can run normally and meet the requirements.

5. Follow-up maintenance and maintenance

After the installation of solar panels, regular maintenance and maintenance work is also required. This includes regularly cleaning the surface of the board of dust and dirt, checking the connection of cables and connectors, checking the operating status of the inverter and junction box, etc. Through timely maintenance and maintenance work, you can ensure the stable operation of the solar panel power generation system and extend the service life.

In short, the installation of solar panels on the roof is a complex and meticulous work, which requires us to make full preparation and planning in the early preparation, installation of brackets, installation of panels, installation of junction boxes and inverters, and system debugging and acceptance. Only in this way can we ensure the normal operation and maximum benefit of the solar panel power generation system.